Launching the Application

The following section describes how to launch the System Administration & Diagnostics application.

 NOTE: You must have local administrative rights to launch the application.

To launch the System Administration & Diagnostics application:

1. Select Start – All Programs – Mitel System Administration & Diagnostics. If there are no programmed connections, the System Administration & Diagnostics Welcome window appears.

When the System Administration & Diagnostics application is installed on a computer, system connections programmed on the computer either by a previous installation of System Administration & Diagnostics or an earlier version of DB Programming are preserved. If the connections were programmed using an earlier version of DB Programming (previously known as “sessions” programmed in the Session Manager used for pre-v4.0 systems), those connections are automatically imported into the System Administration & Diagnostics application. If the installation is an upgrade from an earlier version of System Administration & Diagnostics, the system connections are simply preserved. In either of those cases, the Welcome Window is not shown.

2. Do one of the following:

1. • Importing connections.

   • Adding connections manually.

   • Exiting without Adding or Importing Connections.

When the System Administration & Diagnostics application is connecting to a system, the Information bar displays any of the following information:

• Connecting Information

• Success Information

• System Status Information

• Warning Information

• Failure Information

• Waiting/Disconnecting/Cancelling Information

• Connection Retry Information

• Disconnected Information

Related Topics:

Backups Tab

Managing System Connections